M Menu
b 0 Items s

COVID-19 UPDATE: Our web shop currently remains open to customers. We are constantly reviewing this in light of government advice and in discussion with our fulfilment partners. However, delays in local delivery may occur which are outside of our control - we apologise in advance for this.

R9097 D7101 Decoder Installation

The following guide will aid you with the installation of a standard Hornby decoder into the Thomas & Friends R9097 'D7101' locomotive

R9097 D7101 Decoder Installation 1

Step 1. Carefully remove the body by gently pulling the body sides apart releasing the body locating lugs located by the cab steps and then pull the chassis down.

R9097 D7101 Decoder Installation 2

Step 2. Locate the orange capacitor situated on the side of the motor. The capacitor has two wires attached to each "leg". Bend the capacitor away from the motor to make the attached wires accessible.

R9097 D7101 Decoder Installation 3

Step 3. Unsolder the two black wires from the leg of the capacitor as shown. If these wires become unsoldered from each other in the process, simply resolder them ready for fitting the decoder.

R9097 D7101 Decoder Installation 4

Step 4. Unsolder the two red wires from the other leg of the capacitor as shown. If these wires become unsoldered from each other in the process, simply resolder them ready for fitting the decoder.

R9097 D7101 Decoder Installation 5

Step 5. Remove the decoder from the protective packaging, taking care not to handle the PCB directly as this will cause irreparable damage due to static electricity. It is important to protect the decoder by wrapping the PCB with insulating tape. To prepare the decoder, remove the plug and separate the red, black, orange and grey wires. The rest can but cut as short as possible and insulated with a piece of insulating tape. Strip the red, black, orange and grey wires and lightly "tin" them with solder. Tinning the wires will make the installation easier. When soldering care must be taken not to breathe in the fumes.

R9097 D7101 Decoder Installation 6

Step 6. Solder the black wire from the decoder to the first pair of black pick up wires as shown.

R9097 D7101 Decoder Installation 7

Step 7. Solder the red wire from the decoder to the second pair of red pickup wires as shown.

R9097 D7101 Decoder Installation 8

Step 8. Solder the orange wire from the decoder to the first capacitor leg as shown.

R9097 D7101 Decoder Installation 9

Step 9. Solder the grey wire from the decoder to the second leg of the capacitor as shown.

R9097 D7101 Decoder Installation 10

Step 10. Ensure that none of the new joints are touching each other or any metal parts, and place the locomotive onto the programming track and test to make sure that the installation has been successful. Remember that the decoder has a default number of “3” and it is recommended that you code the locomotive to the number you require and test again.

R9097 D7101 Decoder Installation 11

Step 11. Insulate any bare joints as shown and secure the decoder against the locomotives chassis using BlueTack or an other suitable fixative.

R9097 D7101 Decoder Installation 12

Step 12. Place the locomotive onto the test track and test again. Once you are satisfied that the decoder is functioning correctly, replace the loco body, ensuring that there are no wires caught in any moving parts, or 'pinched' between the chassis and the body. Test once more to ensure that the installation has been totally successful.

R9097 D7101 Decoder Installation13


This site uses cookies to provide users with the best experience possible, to find out more about them or how to remove cookies from your browser please view our Privacy Policy Or accept cookies to continue to use the website.
Membership Restricted Product